Articles & Blog
SATURDAY, DECEMBER 8, 2012
DIMENSIONS 36" x 20" INTERFACE Vertex Tri-Buffer (single input buffer, dual output buffer) with a polarity switch and isolation transformer on the right output for a stereo amplifier set-up, with ability to sum L and R outputs to MONO when...
Read MoreMONDAY, NOVEMBER 26, 2012
DIMENSIONS 14" x 12" INTERFACE Vertex Tri-Buffer (single input buffer, dual output buffer) with a polarity switch and isolation transformer on the right output for a stereo amplifier set-up, and effects "break-out" to insert pedals off of the pedalboard between...
Read MoreTHURSDAY, NOVEMBER 15, 2012
DIMENSIONS 23" x 16" INTERFACE Vertex Dual Buffer (single input and output buffer), MIDI I/O, TRS I/O (for amp footswitch), Switchable Effects Loop (to assign the Volume, Delay, and Reverb pedals to either the effects loop OR in front of...
Read MoreTHURSDAY, OCTOBER 4, 2012
This is a strictly fuzz pedalboard for Henry Kaiser's studio to use as a satellite to his larger pedalboards when recording. INTERFACE N/A CABLE Vertex Cable (small diameter) CONNECTORS Vertex R/A and Pancake 1/4" connectors POWER SUPPLY Voodoo Lab Pedal...
Read MoreTHURSDAY, OCTOBER 4, 2012
Here's an update to Matt's first Vertex board which includes his new signature prototype FTT SOV-2 Overdrive and integrates the footswitch for his signature Two-Rock amp. This is a before and after of Matt's pre-Vertex board and his most current...
Read MoreSUNDAY, SEPTEMBER 30, 2012
This pedalboard was custom made for Jacob Petersen (guitarist for the Steve Miller Band), for his solo projects. INTERFACE Vertex Dual Buffer (input and output buffer). CABLE Vertex Cable CONNECTORS Vertex 1/4" Pancake and Straight POWER SUPPLY Voodoo Lab Pedal...
Read MoreSATURDAY, SEPTEMBER 22, 2012
INTERFACE No input buffer and dual output buffer (to run the system in stereo) with an isolation transformer on the RIGHT output with a polarity switch. CABLE Planet Waves CONNECTORS Vertex R/A and Straight 1/4" Rapco Pancake TRS POWER SUPPLIES...
Read MoreSUNDAY, SEPTEMBER 9, 2012
INTERFACE Vertex Tri-Buffer (single input buffer and dual output buffer) with a polarity switch and isolation transformer on the right output for a stereo amplifier set-up, effects break-out to insert pedals off of the pedalboard between the distortion pedals and...
Read MoreSUNDAY, SEPTEMBER 9, 2012
INTERFACE Vertex tri-buffer (single input and dual output buffer) with polarity switch and isolation transformer for Amp B. There is also a effects break-out to add in pedals off of the pedalboard before the distortion pedals, an effects loop going...
Read MoreWEDNESDAY, AUGUST 15, 2012
Here is a pedalboard that I did for Kirk Fletcher. For the last two years, Kirk has been using a larger pedalboard that I built for him, however he was finding that with frequent trips to Europe and smaller...
Read More